1-19
To do… Use the command… Remarks
Configure statistics
interval and the
maximum number of
retained statistics
information
statistics { interval interval |
max-group number }
Optional
By default, statistics interval is 120 minutes
and up to two pieces of statistics
information can be retained.
Configure the
retaining time of
statistics information
statistics keep-time
keep-time
Optional
By default, the retaining time of statistics
information is 120 minutes.
Configure test start
time and lifetime
test-time begin { hh:mm :ss
[ yyyy/mm/dd ] | now }
lifetime lifetime
Optional
By default, no test start time and lifetime is
configured.
Enable routing table
bypass
sendpacket passroute
Optional
By default, routing table bypass is disabled.
Configure the TTL
ttl number
Optional
By default, TTL is 20.
The sendpacket passroute command voids
the ttl command.
Configure the
automatic test interval
frequency interval
Optional
By default, the automatic test interval is
zero seconds, indicating no automatic test
will be made.
Configure the probe
timeout time
timeout time
Optional
By default, a probe times out in three
seconds.
Configure the service
type
tos value
Optional
By default, the service type is zero.
Start the test
test-enable
Required
Display test results
display remote-ping
results [ admin-name
operation-tag ]
Required
The display command can be executed in
any view.
9) Configuring DNS test on remote-ping client
Follow these steps to configure DNS test on remote-ping client:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the remote-ping client
function
remote-ping-agent enable
Required
By default, the remote-ping
client function is disabled.
Create a remote-ping test
group and enter its view
remote-ping
administrator-name operation-
tag
Required
By default, no test group is
configured.
Configure the source IP
address
source-ip ip-address
Optional
By default, no source IP
address is specified.
To Next Page
Loading...