Ethernet Port Configuration 99
■ The local switch sends a message to notify the peer switch of stopping sending
packets to itself or reducing the sending rate temporarily.
■ The peer switch will stop sending packets to the local switch or reduce the
sending rate temporarily when it receives the message; and vice versa. By this
way, packet loss is avoided and the network service operates normally.
Configuring an Access
Port
Configuring a Hybrid
Port
Tab le 59 Enable flow control on a port
Operation Command Remarks
Enter system view system-view -
Enter Ethernet port view interface interface-type
interface-number
-
Enable flow control on the
Ethernet port
flow-control By default, flow control is not
enabled on the port.
Tab le 60 Configure access port attribute
Operation Command Remarks
Enter system view system-view -
Enter Ethernet port view interface interface-type
interface-number
-
Set the link type of the port to
access
port link-type access Optional
By default, the link type of a
port is access.
Add the current access port to
a specified VLAN
port access vlan vlan-id Optional
Tab le 61 Configure hybrid port attribute
Operation Command Remarks
Enter system view system-view -
Enter Ethernet port view interface interface-type
interface-number
-
Set the link type of the port to
hybrid
port link-type hybrid Required
Set the default VLAN ID for
the port
port hybrid pvid vlan
vlan-id
Optional
If no default VLAN ID is set for
a hybrid port, VLAN 1 (system
default VLAN) is used as the
default VLAN of the port.
Add the port to specified
VLANs
port hybrid vlan vlan-id-list {
tagged | untagged }
Optional
The tagged/untagged
keyword specifies to
keep/remove the VLAN tags
carried in the packets of
specific VLANs when the
packets are forwarded
through the port.
To Next Page
Loading...
