456 CHAPTER 40: INFORMATION CENTER
Between "module" and "level" is a "/".
Level (Severity)
System information can be divided into eight levels based on its severity, from 1 to
8. Refer to
Table 338 for definition and description of these severity levels. Note
that there is a forward slash "/" between the level (severity) and digest fields.
Digest
The digest field is a string of up to 32 characters, outlining the system information.
Note that there is a colon between the digest and content fields.
Content
This field provides the content of the system information.
n
The above section describes the log information format sent to a log host by a
switch. Some log host software will resolve the received information as well as its
format, so that you may see the log format displayed on the log host is different
from the one described in this manual.
Information Center
Configuration
Introduction to the
Information Center
Configuration Tasks
Configuring
Synchronous
Information Output
Synchronous information output refers to the feature that if the system
information such as log, trap, or debugging information is output when the user is
inputting commands, the command line prompt (in command editing mode a
prompt, or a [Y/N] string in interaction mode) and the input information are
echoed after the output.
This feature is used in the case that your input is interrupted by a large amount of
system output. With this feature enabled, the system echoes your previous input
and you can continue your operations from where you were stopped.
Tabl e 341 Information center configuration tasks
Task Remarks
“Configuring Synchronous Information Output” on page 456 Optional
“Displaying the Time Stamp with the UTC Time Zone” on page 457
“Setting to Output System Information to the Console” on page 457 Optional
“Setting to Output System Information to a Monitor Terminal” on
page 459
Optional
“Setting to Output System Information to a Log Host” on page 460 Optional
“Setting to Output System Information to the Trap Buffer” on
page 461
Optional
“Setting to Output System Information to the Log Buffer” on
page 461
Optional
“Setting to Output System Information to the SNMP NMS” on
page 462
Optional
To Next Page
Loading...
