3Com 4210 PWR - 44 Device Management; Device Management Configuration

44
DEVICE MANAGEMENT
Device Management
Configuration
Device Management
Configuration Tasks
Rebooting the Ethernet
Switch
You can perform the following operation in user view when the switch is faulty or
needs to be rebooted.
n
Before rebooting, the system checks whether there is any configuration change. If
yes, it prompts whether or not to proceed. This prevents the system from losing
the configurations in case of shutting down the system without saving the
configurations
Scheduling a Reboot on
the Switch
After you schedule a reboot on the switch, the switch will reboot at the specified
time.
Tab le 361 Device management configuration tasks
Task Remarks
“Rebooting the Ethernet Switch” Optional
“Scheduling a Reboot on the Switch” Optional
“Configuring Real-time Monitoring of the
Running Status of the System”
Optional
“Specifying the APP to be Used at Reboot” Optional
“Upgrading the Boot ROM” Optional
Tab le 362 Reboot the Ethernet switch
Operation Command Description
Reboot the Ethernet switch reboot [ unit unit-id ] Available in user view
Tab le 363 Schedule a reboot on the switch
Operation Command Description
Schedule a reboot on the
switch, and set the reboot
date and time
schedule reboot at hh:mm [
mm/dd/yyyy | yyyy/mm/dd ]
Optional
Schedule a reboot on the
switch, and set the delay time
for reboot
schedule reboot delay {
hh:mm | mm }
Optional
Enter system view system-view -
Schedule a reboot on the
switch, and set the reboot
period
schedule reboot regularity
at hh:mm period
Optional