EasyManua.ls Logo

3Com 4210 PWR - TFTP Configuration

3Com 4210 PWR
567 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
446 CHAPTER 39: TFTP CONFIGURATION
TFTP Configuration
Basic configurations on
a TFTP client
By default a switch can operate as a TFTP client. In this case you can connect the
switch to the TFTP server to perform TFTP-related operations (such as
creating/removing a directory) by executing commands on the switch.
Table 337
lists the operations that can be performed on a TFTP client.
TFTP Configuration
Example
Network requirements
A switch operates as a TFTP client and a PC as the TFTP server. The application
named switch.bin is stored on the PC. Download it (switch.bin) to the switch
through TFTP, and use the boot boot-loader command to specify switch.bin as
the application for next startup. Reboot the switch to upload the configuration file
named config.cfg to the work directory on the PC to back up the configuration
file.
The TFTP working directory is configured on the TFTP server.
Configure the IP addresses of a VLAN interface on the switch and the PC as
1.1.1.1 and 1.1.1.2 respectively. The port through which the switch connects
with the PC belongs to the VLAN.
Network diagram
Figure 152 Network diagram for TFTP configurations
Configuration procedure
1 Configure the TFTP server (PC)
Start the TFTP server and configure the working directory on the PC.
2 Configure the TFTP client (switch).
Tabl e 337 Basic configurations on a TFTP client
Operation Command Description
Download a file from a TFTP
server
tftp [ tftp-server | ipv6
ipv6-tftp-server [ -i interface-type
interface-number ] get source-file [
dest-file ]
Optional
Upload a file to a TFTP server tftp [ tftp-server | ipv6
ipv6-tftp-server [ -i interface-type
interface-number ] put source-file [
dest-file ]
Optional
Enter system view system-view -
Set the file transmission mode tftp { ascii | binary } Optional
Binary by default
Specify an ACL rule used by
the specified TFTP client to
access a TFTP server
tftp-server acl acl-number Optional
Not specified by default
Network
Switch
PC
TFTP Client
TFTP Server
Vlan-Int1
1.1.1.1/24
1.1.1.2/24

Table of Contents

Related product manuals