Information Center Configuration 457
n
■ If the system information is output before you input any information following
the current command line prompt, the system does not echo any command
line prompt after the system information output.
■ In the interaction mode, you are prompted for some information input. If the
input is interrupted by system output, no system prompt (except the Y/N string)
will be echoed after the output, but your input will be displayed in a new line.
Displaying the Time
Stamp with the UTC
Time Zone
To add UTC time zone to the time stamp in the information center output
information, you must:
■ Set the local time zone
■ Set the time stamp format in the output direction of the information center to
date
■ Configure to add the UTC time zone to the output information
Setting to Output
System Information to
the Console
Setting to output system information to the console
Tab le 342 Configure synchronous information output
Operation Command Description
Enter system view system-view -
Enable synchronous
information output
info-center synchronous Required
Disabled by default
Tab le 343 Configure to display time stamp with the UTC time zone
Operation Command Description
Set the time zone for the
system
clock timezone zone-name {
add | minus } time
Required
By default, UTC time zone is
set for the system.
Enter system view system-view -
Set the time
stamp format
in the output
direction of
the
information
center to date
Log host
direction
info-center timestamp
loghost date
Required
Use either command
Non log
host
direction
info-center timestamp { log |
trap | debugging } date
Set to display the UTC
time zone in the output
information of the
information center
info-center timestamp utc Required
By default, no UTC time zone
is displayed in the output
information
Tab le 344 Set to output system information to the console
Operation Command Description
Enter system view system-view -
Enable the information center info-center enable Optional
Enabled by default.
To Next Page
Loading...
