3Com 4210 PWR - Poe Profile Configuration Example

PoE Profile Configuration Example 349
PoE Profile
Configuration
Example
PoE Profile Application
Example
Network requirements
Switch A is a Switch 4210 that supports PoE.
Ethernet 1/0/1 through Ethernet 1/0/10 of Switch A are used by users of group A,
who have the following requirements:
■ The PoE function can be enabled on all ports in use.
■ Signal mode is used to supply power.
■ The PoE priority for Ethernet 1/0/1 through Ethernet 1/0/5 is Critical, whereas
the PoE priority for Ethernet 1/0/6 through Ethernet 1/0/10 is High.
■ The maximum power for Ethernet 1/0/1 through Ethernet 1/0/5 ports is 3,000
mW, whereas the maximum power for Ethernet 1/0/6 through Ethernet 1/0/10
is 15,400 mW.
Based on the above requirements, two PoE profiles are made for users of group A.
■ Apply PoE profile 1 for Ethernet 1/0/1 through Ethernet 1/0/5;
■ Apply PoE profile 2 for Ethernet 1/0/6 through Ethernet 1/0/10.
Network diagram
Figure 105 PoE profile application
Network
IP Pone
Switch A
AP
IP Pone
IP Pone
IP Pone
AP
AP
AP
Ethernet1/0/1~Ethernet1/0/5 Ethernet 1/0/6~Ethernet1/0/10