462 CHAPTER 40: INFORMATION CENTER
Setting to Output
System Information to
the SNMP NMS
n
To send information to a remote SNMP NMS properly, related configurations are
required on both the switch and the SNMP NMS.
Displaying and
Maintaining
Information Center
After the above configurations, you can execute the display commands in any
view to display the running status of the information center, and thus validate your
configurations. You can also execute the reset commands in user view to clear the
information in the log buffer and trap buffer.
Configure the output rules of
system information
info-center source {
modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity |
state state } ]*
Optional
Refer to Table 345 for the
default output rules of system
information.
Set the format of time stamp
in the output information
info-center timestamp { log
| trap | debugging } { boot |
date | none }
Optional
By default, the time stamp
format of the output log
information is date.
Table 351 Set to output system information to the log buffer
Operation Command Description
Tabl e 352 Set to output system information to the SNMP NMS
Operation Command Description
Enter system view system-view -
Enable the information center info-center enable Optional
Enabled by default.
Enable information output to
the SNMP NMS
info-center snmp channel {
channel-number |
channel-name }
Optional
By default, the switch outputs
trap information to SNMP
through channel 5.
Configure the output rules of
system information
info-center source {
modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity |
state state } ]*
Optional
Refer to Table 345 for the
default output rules of system
information.
Set the format of time stamp
in the output information
info-center timestamp { log
| trap | debugging } { boot |
date | none }
Optional
By default, the time stamp
format of the information
output to the SNMP NMS is
date.
To Next Page
Loading...
