3Com 4210 PWR - Configuring Basic SNMP Functions

Configuring Basic SNMP Functions 353
Configuring Basic
SNMP Functions
SNMPv3 configuration is quite different from that of SNMPv1 and SNMPv2c.
Therefore, the configuration of basic SNMP functions is described by SNMP
versions, as listed in
Table 273 and Table 274.
Private MIB DHCP MIB
QACL MIB
MSTP MIB
VLAN MIB
IPV6 ADDRESS MIB
MIRRORGROUP MIB
QINQ MIB
802.x MIB
Switch Clustering MIB
NTP MIB
Device management
Interface management
-
Table 272 Common MIBs
MIB attribute MIB content Related RFC
Tab le 273 Configure basic SNMP functions (SNMPv1 and SNMPv2c)
Operation Command Description
Enter system view system-view -
Enable SNMP agent snmp-agent Optional
Disabled by default.
You can enable SNMP
agent by executing this
command or any of the
commands used to
configure SNMP agent.
Set system information, and specify
to enable SNMPv1 or SNMPv2c on
the switch
snmp-agent sys-info {
contact sys-contact |
location sys-location |
version { { v1 | v2c | v3 }* |
all } }
Required
By default, the contact
information for system
maintenance is "R&D
Hangzhou, 3Com
Technology Co., Ltd.",
the system location is
"Hangzhou China", and
the SNMP version is
SNMPv3.