3Com 4210 PWR - Setting to Output System Information to the Trap Buffer; Setting to Output System Information to the Log Buffer

Information Center Configuration 461
n
Be sure to set the correct IP address when using the info-center loghost
command. A loopback IP address will cause an error message prompting that this
address is invalid.
Setting to Output
System Information to
the Trap Buffer
Setting to Output
System Information to
the Log Buffer
Configure the output rules of
system information
info-center source {
modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity |
state state } ]*
Optional
Refer to Table 345 for the
default output rules of system
information.
Set the format of the time
stamp to be sent to the log
host
info-center timestamp
loghost { date |
no-year-date | none }
Optional
By default, the time stamp
format of the information
output to the log host is date.
Table 349 Set to output system information to a log host
Operation Command Description
Tab le 350 Set to output system information to the trap buffer
Operation Command Description
Enter system view system-view -
Enable the information center info-center enable Optional
Enabled by default.
Enable system information
output to the trap buffer
info-center trapbuffer
[channel { channel-number |
channel-name } | size
buffersize]*
Optional
By default, the switch uses
information channel 3 to
output trap information to the
trap buffer, which can holds
up to 256 items by default.
Configure the output rules of
system information
info-center source {
modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity |
state state } ]*
Optional
Refer to Table 345 for the
default output rules of system
information.
Set the format of time stamp
in the output information
info-center timestamp { log
| trap | debugging } { boot |
date | none }
Optional
By default, the time stamp
format of the output trap
information is date.
Tab le 351 Set to output system information to the log buffer
Operation Command Description
Enter system view system-view -
Enable the information center info-center enable Optional
Enabled by default.
Enable information output to
the log buffer
info-center logbuffer [
channel { channel-number |
channel-name } | size
buffersize ]*
Optional
By default, the switch uses
information channel 4 to
output log information to the
log buffer, which can holds
up to 512 items by default.