Displaying and Maintaining Cluster Configuration 333
Displaying and
Maintaining Cluster
Configuration
After the above configuration, you can execute the display commands in any
view to display the configuration and running status of cluster, so as to verify your
configuration.
Cluster Configuration
Example
Basic Cluster
Configuration Example
Network requirements
Three switches compose a cluster, where:
■ The Switch 4210 serves as the management device.
■ The rest are member devices.
Delete the specified MAC
address from the cluster
blacklist
black-list delete-mac
mac-address
Optional
Delete a device from the
cluster add this device to the
cluster blacklist
delete-member member-id [
to-black-list ]
Optional
Displays the information
about the devices in the
cluster blacklist
display cluster black-list Optional
This command can be
executed in any view.
Table 257 Configure the cluster device blacklist
Operation Command Description
Tab le 258 Display and maintain cluster configuration
Operation Command Description
Display all NDP configuration
and running information
(including the interval to send
NDP packets, the holdtime,
and all neighbors discovered)
display ndp You can execute the display
command in any view.
Display NDP configuration
and running information on
specified ports (including the
neighbors discovered by NDP
on the ports)
display ndp interface
port-list
Display global NTDP
information
display ntdp
Display device information
collected by NTDP
display ntdp device-list [
verbose ]
Display status and statistics
information about the cluster
display cluster
Display information about the
candidate devices of the
cluster
display cluster candidates [
mac-address H-H-H |
verbose ]
Display information about the
member devices of the cluster
display cluster members [
member-number | verbose ]
Clear the statistics on NDP
ports
reset ndp statistics [
interface port-list ]
You can execute the reset
command in user view.
To Next Page
Loading...
