332 CHAPTER 30: CLUSTER
Configure cluster topology management function
1 Configuration prerequisites
Before configuring the cluster topology management function, make sure that:
■ The basic cluster configuration is completed.
■ Devices in the cluster work normally.
2 Configuration procedure
Perform the following configuration on the management device.
Configure cluster device blacklist
Perform the following configuration on the management device.
Tabl e 256 Configure cluster topology management function
Operation Command Description
Enter system view system-view -
Enter cluster view cluster -
Check the current topology
and save it as the standard
topology.
topology accept { all [
save-to { ftp-server |
local-flash } ] | mac-address
mac-address | member-id
member-id | administrator }
Required
Save the standard topology to
the Flash memory of the
administrative device
topology save-to
local-flash
Required
Restore the standard topology
from the Flash memory of the
administrative device
topology restore-from
local-flash
Optional
Display the detailed
information about a single
device
display ntdp single-device
mac-address mac-address
Optional
These commands can be
executed in any view.
Display the topology of the
current cluster
display cluster
current-topology [
mac-address mac-address1 [
to-mac-address
mac-address2 ] | member-id
member-id1 [ to-member-id
member-id2 ] ]
Display the information about
the base topology of the
cluster
display cluster
base-topology [
mac-address mac-address |
member member-id ]
Display the information about
all the devices in the base
cluster topology
display cluster
base-members
Tabl e 257 Configure the cluster device blacklist
Operation Command Description
Enter system view system-view -
Enter cluster view cluster -
Add the MAC address of a
specified device to the cluster
blacklist
black-list add-mac
mac-address
Optional
By default, the cluster blacklist
is empty.
To Next Page
Loading...
