84 CHAPTER 6: MANAGING THE VLAN
Configuring VLAN
Management
Before configuring the management VLAN, make sure the VLAN operating as the
management VLAN exists. If VLAN 1 (the default VLAN) is the management VLAN,
just go ahead.
Overviw
c
Caution: To create the VLAN interface for the management VLAN on a switch
operating as the management device in a cluster, make sure that the management
VLAN ID is consistent with the cluster management VLAN ID configured with the
management-vlan vlan-id command. Otherwise, the configuration fails. Refer to
the Cluster Operation Manual for detailed introduction to the cluster. Refer to the
VLAN module for detailed introduction to VLAN interfaces.
Configuration Example Network requirements
For a user to manage Switch A remotely through Telnet, these requirements are to
be met: Switch A has an IP address, and the remote Telnet user is reachable.
You need to configure the switch as follows:
■ Assigning an IP address to the management VLAN interface on Switch A
■ Configuring the default route
Tabl e 46 Configure the management VLAN
Operation Command Remarks
Enter system view system-view -
Configure a specified VLAN to be
the management VLAN
management-vlan vlan-id Required.
By default, VLAN 1
operates as the
management VLAN.
Create the management VLAN
interface and enter the
corresponding VLAN interface view
interface vlan-interface
vlan-id
Required
Assign an IP address to the
management VLAN interface
ip address ip-address mask Required.
By default, no IP address is
assigned to the
management VLAN
interface.
Configure a static route ip route-static ip-address {
mask | mask-length } {
interface-type
interface-number | next-hop
} [ preference
preference-value ] [ reject |
blackhole ] [ description
text ]
Optional
To Next Page
Loading...
