Enabling Logging for Network Management 357
Enabling Logging for
Network Management
n
IUse the display logbuffer command to view the log of the get and set
operations requested by the NMS.
Displaying SNMP After the above configuration, you can execute the display command in any view
to view the running status of SNMP, and to verify the configuration.
SNMP Configuration
Examples
SNMP Configuration
Examples
Network requirements
■ An NMS and Switch A (SNMP agent) are connected through the Ethernet. The
IP address of the NMS is 10.10.10.1 and that of the VLAN interface on Switch
A is 10.10.10.2.
■ Perform the following configuration on Switch A: setting the community name
and access permission, administrator ID, contact and switch location, and
enabling the switch to sent trap messages.
Tab le 277 Enable logging for network management
Operation Command Description
Enter system view system-view -
Enable logging for network
management
snmp-agent log {
set-operation |
get-operation | all }
Optional
Disabled by default.
Tab le 278 Display SNMP
Operation Command Description
Display the SNMP information
about the current device
display snmp-agent
sys-info [ contact | location |
version ]*
Available in any view.
Display SNMP packet statistics display snmp-agent
statistics
Display the switch fabric ID of
the current device
display snmp-agent {
local-switch fabricid |
remote-switch fabricid }
Display group information
about the device
display snmp-agent group [
group-name ]
Display SNMP user
information
display snmp-agent
usm-user [ switch fabricid
switch fabricid | username
user-name | group
group-name ]
Display Trap list information display snmp-agent
trap-list
Display the currently
configured community name
display snmp-agent
community [ read | write ]
Display the currently
configured MIB view
display snmp-agent
mib-view [ exclude | include
| viewname view-name ]
To Next Page
Loading...
