3Com 4210 PWR - Setting to Output System Information to a Monitor Terminal

Information Center Configuration 459
n
Make sure that the debugging/log/trap information terminal display function is
enabled (use the terminal monitor command) before you enable the
corresponding terminal display function by using the terminal debugging,
terminal logging, or terminal trapping command.
Setting to Output
System Information to a
Monitor Terminal
System information can also be output to a monitor terminal, which is a user
terminal that has login connections through the AUX, VTY, or TTY user interface.
Setting to output system information to a monitor terminal
n
■ When there are multiple Telnet users or dumb terminal users, they share some
configuration parameters including module filter, language and severity level
threshold. In this case, change to any such parameter made by one user will
also be reflected on all other user terminals.
■ To view debugging information of specific modules, you need to set the
information type as debug when setting the system information output rules,
Enable debugging
information terminal display
function
terminal debugging Optional
Disabled by default.
Enable log information
terminal display function
terminal logging Optional
Enabled by default.
Enable trap information
terminal display function
terminal trapping Optional
Enabled by default.
Table 346 Enable the system information display on the console:
Operation Command Description
Tab le 347 Set to output system information to a monitor terminal
Operation Command Description
Enter system view system-view -
Enable the information center info-center enable Optional
Enabled by default.
Enable system information
output to Telnet terminal or
dumb terminal
info-center monitor
channel { channel-number |
channel-name }
Optional
By default, a switch outputs
log/debugging/trap
information to a user terminal
through information channel
1.
Configure the output rules of
system information
info-center source {
modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity |
state state } ]*
Optional
Refer to Table 345 for the
default output rules of system
information.
Set the format of time stamp
in the output information
info-center timestamp { log
| trap | debugging } { boot |
date | none }
Optional
By default, the time stamp
format of the log and trap
output information is date,
and that of the debugging
output information is boot.