3Com 4210 PWR - Page 460

458 CHAPTER 40: INFORMATION CENTER
n
To view the debugging information of some modules on the switch, you need to
set the type of the output information to debug when configuring the system
information output rules, and use the debugging command to enable debugging
for the corresponding modules.
Enabling system information display on the console
After setting to output system information to the console, you need to enable the
associated display function to display the output information on the console.
Enable system information
output to the console
info-center console channel
{ channel-number |
channel-name }
Optional
By default, the switch uses
information channel 0 to
output log/debugging/trap
information to the console.
Configure the output rules of
system information
info-center source {
modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity |
state state } ]*
Optional
Refer to Table 345 for the
default output rules of system
information.
Set the format of time stamp
in the output information
info-center timestamp { log
| trap | debugging } { boot |
date | none }
Optional
By default, the time stamp
format of the log and trap
output information is date,
and that of the debugging
output information is boot.
Table 344 Set to output system information to the console
Operation Command Description
Tabl e 345 Default output rules for different output directions
Output
direction
Modules
allowed
LOG TRAP DEBUG
Enable
d/disab
led
Severit
y
Enabled/
disabled
Severity
Enabled/
disabled
Severity
Console default (all
modules)
Enabled warning
s
Enabled debuggin
g
Enabled debuggin
g
Monitor
terminal
default (all
modules)
Enabled warning
s
Enabled debuggin
g
Enabled debuggin
g
Log host default (all
modules)
Enabled informat
ional
Enabled debuggin
g
Disabled debuggin
g
Trap buffer default (all
modules)
Disabled informat
ional
Enabled warnings Disabled debuggin
g
Log buffer default (all
modules)
Enabled warning
s
Disabled debuggin
g
Disabled debuggin
g
SNMP NMS default (all
modules)
Disabled debuggi
ng
Enabled warnings Disabled debuggin
g
Tabl e 346 Enable the system information display on the console:
Operation Command Description
Enable the
debugging/log/trap
information terminal display
function
terminal monitor Optional
Enabled by default.