460 CHAPTER 40: INFORMATION CENTER
and enable debugging for corresponding modules through the debugging
command.
Enabling system information display on a monitor terminal
After setting to output system information to a monitor terminal, you need to
enable the associated display function in order to display the output information
on the monitor terminal.
n
Make sure that the debugging/log/trap information terminal display function is
enabled (use the terminal monitor command) before you enable the
corresponding terminal display function by using the terminal debugging,
terminal logging, or terminal trapping command.
Setting to Output
System Information to a
Log Host
Tabl e 348 Enable the display of system information on a monitor terminal
Operation Command Description
Enable the
debugging/log/trap
information terminal display
function
terminal monitor Optional
Enabled by default
Enable debugging
information terminal display
function
terminal debugging Optional
Disabled by default
Enable log information
terminal display function
terminal logging Optional
Enabled by default
Enable trap information
terminal display function
terminal trapping Optional
Enabled by default
Tabl e 349 Set to output system information to a log host
Operation Command Description
Enter system view system-view -
Enable the information center info-center enable Optional
Enabled by default.
Enable system information
output to a log host
info-center loghost
host-ip-addr [ channel {
channel-number |
channel-name } | facility
local-number ]*
Required
By default, the switch does
not output information to the
log host.
After you configure the switch
to output information to the
log host, the switch uses
information channel 2 by
default.
Configure the source
interface through which log
information is sent to the log
host
info-center loghost source
interface-type
interface-number
Optional
By default, no source interface
is configured, and the system
automatically selects an
interface as the source
interface.
To Next Page
Loading...
