28 CHAPTER 2: LOGGING INTO AN ETHERNET SWITCH
Configure the
Console port
Set the baud rate speed speed-value Optional
The default baud rate of a
Console port is 19,200
bps.
Set the check
mode
parity { even | none |
odd }
Optional
By default, the check
mode of a Console port is
none, that is, no check is
performed.
Set the stop bits stopbits { 1 | 1.5 | 2 } Optional
The stop bits of a Console
port is 1.
Set the data bits databits { 7 | 8 } Optional
The default data bits of a
Console port is 8.
Configure the command level
available to users logging into the user
interface
user privilege level level Optional
By default, commands of
level 3 are available to
users logging into the
AUX user interface, and
commands of level 0 are
available to users logging
into the VTY user
interface.
Enable terminal services shell Optional
By default, terminal
services are available in all
user interfaces.
Set the maximum number of lines the
screen can contain
screen-length
screen-length
Optional
By default, the screen can
contain up to 24 lines.
You can use the
screen-length 0
command to disable the
function to display
information in pages.
Set the history command buffer size history-command
max-size value
Optional
The default history
command buffer size is
10. That is, a history
command buffer can
store up to 10 commands
by default.
Table 14 Console port login configuration with the authentication mode being none
Operation Command Description
To Next Page
Loading...
