326 CHAPTER 30: CLUSTER
Configuring NDP-related parameters
Enabling NTDP globally and on a specific port
Configuring NTDP-related parameters
Enable NDP globally ndp enable Required
By default, NDP is
enabled globally.
Enable NDP
on specified
Ethernet
ports
In system view ndp enable interface
port-list
Use either approach.
By default, NDP is
enabled on a port.
In Ethernet
port view
Enter
Ethernet
port view
interface interface-type
interface-number
Enable NDP
on the port
ndp enable
Tabl e 243 Configure NDP-related parameters
Operation Command Description
Enter system view system-view -
Configure the holdtime of
NDP information
ndp timer aging
aging-in-seconds
Optional
By default, the holdtime of
NDP information is 180
seconds.
Configure the interval to send
NDP packets
ndp timer hello seconds Optional
By default, the interval to
send NDP packets is 60
seconds.
Tabl e 244 Enable NTDP globally and on a specific port
Operation Command Description
Enter system view system-view -
Enable NTDP globally ntdp enable Required
Enabled by default
Enter Ethernet port view interface interface-type
interface-number
-
Enable NTDP on the Ethernet
port
ntdp enable Required
Enabled by default
Tabl e 245 Configure NTDP-related parameters
Operation Command Description
Enter system view system-view -
Configure the range to collect
topology information
ntdp hop hop-value Optional
By default, the system collects
topology information from
the devices within three hops.
Table 242 Enable NDP globally and on specific ports
Operation Command Description
To Next Page
Loading...
