394 CHAPTER 36: SSH CONFIGURATION
■ For details of the header command, see the corresponding section in Login
Command.
Configuring the Client
Public Key on the Server
n
This configuration is not necessary if the password authentication mode is
configured for SSH users.
With the publickey authentication mode configured for an SSH client, you must
configure the client’s RSA or DSA host public key(s) on the server for
authentication.
You can manually configure the public key or import it from a public key file. In the
former case, you can manually copy the client’s public key to the server. In the
latter case, the system automatically converts the format of the public key
generated by the client to complete the configuration on the server, but the
client’s public key should be transferred from the client to the server beforehand
through FTP/TFTP.
You can also use the following commands to configure the client’s RSA public key
on the server.
Tabl e 307 Configure the client’s public key manually
Operation Command Description
Enter system view system-view
Enter public key view public-key peer keyname Required
Enter public key edit view public-key-code begin
Configure a public key for the
client
Enter the content of the
public key
When you input the key data,
spaces are allowed between
the characters you input
(because the system can
remove the spaces
automatically); you can also
press <Enter> to continue
your input at the next line. But
the key you input should be a
hexadecimal digit string
coded in the public key
format.
Return to public key view
from public key edit view
public-key-code end -
Exit public key view and
return to system view
peer-public-key end -
Tabl e 308 Import the public key from a public key file
Operation Command Description
Enter system view system-view -
Import the public key from a
public key file
public-key peer keyname
import sshkey filename
Required
To Next Page
Loading...
