FTP Configuration 433
Specify to transfer files in
ASCII characters
ascii Use either command
By default, files are
transferred in ASCII
characters.
Specify to transfer files in
binary streams
binary
Set the data transfer mode to
passive
passive Optional
passive by default.
Change the working directory
on the remote FTP server
cd pathname Optional
Change the working directory
to be the parent directory
cdup
Get the local working path on
the FTP client
lcd
Display the working directory
on the FTP server
pwd
Create a directory on the
remote FTP server
mkdir pathname
Remove a directory on the
remote FTP server
rmdir pathname
Delete a specified file delete remotefile
Query a specified file on the
FTP server
dir [ remotefile ] [ localfile ] Optional
If no file name is specified, all
the files in the current
directory are displayed.
The difference between these
two commands is that the dir
command can display the file
name, directory as well as file
attributes; while the Is
command can display only the
file name and directory.
ls [ remotefile ] [ localfile ]
Download a remote file from
the FTP server
get remotefile [ localfile ] Optional
Upload a local file to the
remote FTP server
put localfile [ remotefile ]
Rename a file on the remote
server
rename remote-source
remote-dest
Log in with the specified user
name and password
user username [ password ]
Connect to a remote FTP
server
open { ip-address |
server-name } [ port ]
Terminate the current FTP
connection without exiting
FTP client view
disconnect
close
Terminate the current FTP
connection and return to user
view
quit
bye
Display the online help about
a specified command
concerning FTP
remotehelp [
protocol-command ]
Enable the verbose function verbose Optional
Enabled by default
Table 332 Basic configurations on an FTP client
Operation Command Description
To Next Page
Loading...
