3Com 4210 PWR - Page 522

520 CHAPTER 45: REMOTE-PING CONFIGURATION
[4210-Remote-Ping-administrator-snmp] timeout 30
# Start the test.
[4210-Remote-Ping-administrator-snmp] test-enable
# Display test results
[4210-Remote-Ping-administrator-snmp] display Remote-Ping results administrator s
nmp
Remote-Ping entry(admin administrator, tag snmp) test result:
Destination ip address:10.2.2.2
Send operation times: 10 Receive response times: 10
Min/Max/Average Round Trip Time: 9/11/10
Square-Sum of Round Trip Time: 983
Last complete test time: 2000-4-3 8:57:20.0
Extend result:
SD Maximal delay: 0 DS Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0 Operation timeout number: 0
System busy operation number: 0 Connection fail number: 0
Operation sequence errors: 0 Drop operation number: 0
Other operation errors: 0
[4210-Remote-Ping-administrator-snmp] display Remote-Ping history administrator s
nmp
Remote-Ping entry(admin administrator, tag snmp) history record:
Index Response Status LastRC Time
1 10 1 0 2000-04-03 08:57:20.0
2 10 1 0 2000-04-03 08:57:20.0
3 10 1 0 2000-04-03 08:57:20.0
4 10 1 0 2000-04-03 08:57:19.9
5 9 1 0 2000-04-03 08:57:19.9
6 11 1 0 2000-04-03 08:57:19.9
7 10 1 0 2000-04-03 08:57:19.9
8 10 1 0 2000-04-03 08:57:19.9
9 10 1 0 2000-04-03 08:57:19.8
10 10 1 0 2000-04-03 08:57:19.8
For detailed output description, see the corresponding command manual.
TCP Test (Tcpprivate Test)
on the Specified Ports
Network requirements
Both the Remote-Ping client and the Remote-Ping server are Switch 4210s.
Perform a Remote-Ping Tcpprivate test to test time required to establish a TCP
connection between this end (Switch A) and the specified destination end (Switch
B), with the port number set to 8000.
Network diagram
Figure 186 Network diagram for the Tcpprivate test
Configuration procedure
■ Configure Remote-Ping Server (Switch B):
# Enable the Remote-Ping server and configure the IP address and port to listen
on.
Switch A
Switch B
HWPing Client
IP network
10.1.1.1/8 10.2.2.2/8
HWPing Server