58 CHAPTER 2: LOGGING INTO AN ETHERNET SWITCH
Network diagram
Figure 23 Network diagram for login banner configuration
Configuration Procedure
# Enter system view.
<4210> system-view
# Configure the banner "Welcome" to be displayed when a user logs into the
switch through Web.
[4210] header login %Welcome%
Assume that a route is available between the user terminal (the PC) and the
switch. After the above-mentioned configuration, if you enter the IP address of
the switch in the address bar of the browser running on the user terminal and
press <Enter>, the browser will display the banner page, as shown in
Figure 24.
Figure 24 Banner page displayed when a user logs in to the switch through Web
Click <Continue> to enter user login authentication page. You will enter the main
page of the Web-based network management system if the authentication
succeeds.
Enabling/Disabling the
WEB Server
PC Switch
HTTP
Connection
Tabl e 27 Enable/Disable the WEB Server
Operation Command Description
Enter system view system-view -
Enable the Web server ip http shutdown Required
By default, the Web server is enabled.
To Next Page
Loading...
