3Com 5500-EI PWR - Page 282

3-9
To do... Use the command... Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
Set the RIP timers
timers { update
update-timer | timeout
timeout-timer } *
Required
By default, the Update timer is 30 seconds
and the Timeout timer 180 seconds.
When configuring the values of RIP timers, you should take network performance into consideration
and perform consistent configuration on all routers running RIP to avoid unnecessary network traffic
and network route oscillation.
Configuring split horizon
Follow these steps to configure split horizon:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
—
Enable split horizon
rip split-horizon
Required
Enabled by default
Split horizon cannot be disabled on a point-to-point link.
Configuring RIP-1 packet zero field check
Follow these steps to configure RIP-1 packet zero field check:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
Enable the check of the must be zero
field in RIP-1 packets
checkzero
Required
Enabled by default