1-12
To do… Use the command… Remarks
Configure the probe timeout
time
timeout time
Optional
By default, a probe times out in
three seconds.
Configure the type of service
tos value
Optional
By default, the service type is
zero.
Configure the type of HTTP
operation
http-operation { get | post }
Optional
By default, the type of HTTP
operation is get, that is, the
HTTP operation will get data
from the HTTP server.
Configure the HTTP operation
string and HTTP version
http-string string version
Optional
By default, no HTTP operation
string and HTTP version are
configured.
Start the test
test-enable
Required
Display test results
display remote-ping results
[ admin-name operation-tag ]
Required
You can execute the command
in any view.
5) Configuring jitter test on remote-ping client
Follow these steps to configure jitter test on remote-ping client:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the remote-ping client
function
remote-ping-agent enable
Required
By default, the remote-ping
client function is disabled.
Create a remote-ping test
group and enter its view
remote-ping
administrator-name
operation-tag
Required
By default, no test group is
configured.
Configure the destination IP
address
destination-ip ip-address
Required
The destination address must
be the IP address of a UDP
listening service on the
remote-ping server.
By default, no destination
address is configured.
Configure the destination port
destination-port
Port-number
Required
The destination port must be
the port of a UDP listening
service on the remote-ping
server.
By default, no destination port
is configured.
Configure the source IP
address
source-ip ip-address
Optional
By default, no source IP
address is configured.
To Next Page
Loading...
