3D Systems BFB-3000 User Manual

BFB-3000 Set Up and Operations Manual
Document No: D100253 36
Re-attach the
pressure
bearings onto
the
extruders.
Ensure filaments
run on the middle
(smaller) pressure
bearings. If not,
move the
bearings around
using the nose of
the pliers until
they snap into
position.
6
7
8
Tighten the
pressure bearing
springs until they
are fully bound.
(they will be
adjusted from
this position
later.)

3D Systems BFB-3000 Specifications

General

Brand	3D Systems
Model	BFB-3000
Category	3D Printers
Language	English