3D Systems BFB-3000 User Manual

BFB-3000 Set Up and Operations Manual
Document No: D100253 46
6.11.4 Perfect the raft
If analysis of the raft check file yields any problems, you will need to re-examine some of
the setup stages:
ERROR
CORRECTIVE ACTION
Nozzle too high
See “Check the bed is referenced to the
extruder nozzles” (page 28) to adjust the
height at which the nozzle starts printing.
Nozzle to low
See “Check the bed is referenced to the
extruder nozzles” (page 28) to adjust the
height at which the nozzle starts printing.
Nozzle heights appear inconsistent across a
single print
Check the bed is level (page 21).
Track ripping
Check the hot-end nozzles are clean
(page 20).
Purge deposit
Check the hot-end nozzles are clean
(page 20).

3D Systems BFB-3000 Specifications

General

Brand	3D Systems
Model	BFB-3000
Category	3D Printers
Language	English