3D Systems BFB-3000 - Extruder offsets; Level bed; Set Z height

BFB-3000 Set Up and Operations Manual
Document No: D100253 56
9.4.6.1 Extruder offsets
Extruder offsets defines the position of extruders 2 and 3 in the BFB-3000, relative to
extruder 1. Settings here should only be changed after performing a nozzle calibration
print. Visit our website to download the calibration procedure and determine the offsets
values.
>
Extruder 2 X
-44.30
Extruder 2 Y
0.00
Extruder 3 X
-88.60
Extruder 3 Y
0.00
 Use the Z buttons to select the extruders. Use the Y buttons to alter the values.
 Press X+ to save, or Escape to quit without saving.
Incorrect values will severely affect print quality.
9.4.6.2 Level bed
See “Check the bed is level”, page 21.
9.4.7 Set Z height
See “Check the bed is referenced to the extruder nozzles”, page 28.