9.5 Maintenance operations
9.5.1 Updating your printer
Visit our website at www.bitsfrombytes.com to check for free upgrades. This may include:
Firmware (the software inside the control box)
Hardware (mechanical improvements)
9.5.2 Adjusting the nozzle wipe
The nozzle wipe should sit slightly higher than the height of the nozzle tip, so that when the
nozzle is moved over the wipe, the wipe brushes over the nozzle tip.
Use ‘Manual move’ (page 55) to position the nozzle over the nozzle wipe box.
To Next Page
Loading...
Need help?
General
