3D Systems BFB-3000 User Manual

BFB-3000 Set Up and Operations Manual
Document No: D100253 65
 Heat extruder to melt plastic using “Extruder control”, page 37.
 Examine the removed filament to confirm the cause:
 Reload the filament, as per “Load the extruders” (page 31) taking care to prepare the
tip of the filament as specified.
Cut filament
using side cutters
Remove
loaded section
using pliers
Normal drive
shaft teeth
marks
Ground-out
section

3D Systems BFB-3000 Specifications

General

Brand	3D Systems
Model	BFB-3000
Category	3D Printers
Language	English