Remove the label securing the material cap to the side of the cartridge.4.
Carefully pull the cap off of the end of of the material tube.5.
Slide the eyelet seal backwards behind the set line on the tube.6.
Pull out 12”/30 cm of material from the cartridge. Select the checkmark to continue.7.
Cut off 2”/5 cm of material from the end. Select the checkmark to continue.8.
NOTE: Ensure the material is not bent or creased. If the material is not straight, pull
out the damaged material from the cartridge. Cut off and dispose the portion that is
not straight.
To Next Page
Loading...
