NOTE: The print material will begin to back out of the extruder.
Once the print material has been extracted from the extruder, cut off the end of the print material. Select the checkmark to continue.4.
Remove the cartridge from the printer. Select the checkmark to continue.5.
Insert the cleaning filament into the extruder. Select the checkmark to continue.6.
NOTE: The metal clamp stops the end of the material from continuing into the
extruder. You should not reach this point while cleaning the extruder.
When prompted, pull out the cleaning filament from the extruder. Select the checkmark to continue.7.
To Next Page
Loading...
