Correct Closed Z-Gap
Referring to the illustration, the Closed Z-Gap bars (B) should touch the baseline (A).
Incorrect Closed Z-Gap
If there is a gap (B) between the Closed Z-Gap bars and the baseline (A), turn all three print pad
adjustment knobs counter-clockwise (left) 1-step and then print the file again to verify the lines touch. If
the lines do not touch on the second print, adjust the knobs again 1-step and reprint the file. Continue to
do this until the lines meet.
Correct Open Z-Gap
If there is a gap (B) between the Open Z-Gap bars (C) and the baseline (A) and there is no gap between
the Closed Z-Gap bars and the baseline, the Z-Gap is correct.
To Next Page
Loading...
