3Disc FireCR Flash - Step 3: Scan Blank

User Manual
QuantorMed Plus TM -721-EN
23
2.4.4. Step 3: Scan Blank
Figure 2.18. Scan Blank
 The Scan Blank button is enabled after performing the Erase step.
 After the Erase step, insert the cassette with no X-ray exposure into the reader and
click Scan Blank to acquire the first calibration image.
 The mean intensity value of the blank image is displayed beneath the button.
 The mean intensity value of the blank image is displayed in green if the value is within
the acceptable range.
 The mean intensity value of the blank image is displayed in red if the value is not within
the acceptable range.
 If the mean intensity value of the blank image is displayed in red, click Accept to
continue anyways or Reject to try again.
 To lower the mean intensity value of the blank image, click Erase again.