3xLogic VISIX Gen III Series - RTSP Information

Pg. 38
www.3xlogic.com | 877 3xLOGIC | helpdesk@3xlogic.com
Setup - Network Setup
RTSP Information
1
Target Stream - Select the stream you want to configure
2
Time out - Set the RTSP time out.
The session is disconnected after the specified time out.
3
QoS Setting - Set the quality of service to ensure data transfer performance.
4
RTP Multicast - Check RTP Multicast Start/Stop. To activate RTP Multicast.
1. Click “On” button.
2. Enter accessible RTP Multicast IP, port for video stream control, RTP packet TTL.
3. Click “Apply” button.
It is possible to set each RTP Multicast for Stream 1-3 (main, sub, third).
5
Click Apply to save new settings.
Click this button between configruing the different channels or data will not be saved for the preceding channel settings.
6
RTSP Connection information.
2
3
6
1
4
5