REGION SETTINGS
Time Format
This parameter sets the time format for all time based results.
The default setting is 24 Hours.
Date Format
This parameter sets the date format for date based results.
The default setting is DD/MM/YYYY.
Measurement System
This parameter sets the unit type for parameters like temperature readings.
The default setting is Metric.
RF NETWORK DETAILS
Network ID
This parameter sets the network ID of this base station node and its remote / repeater stations in the
network. The entry is four alphanumeric characters.
The default setting is CAFE.
Base Station ID
This parameter identifies the base station. All radios operating to the base station in the same network must
use the same Base Station ID setting.
It is especially important to set different values for each network when two or more networks using the
same frequencies are operating with some overlapping coverage. The entry is an integer from 1 to 8.
Network Radius
This parameter sets the maximum number of hops in this network e.g. in a network with base station,
repeater and remotes communicating via the repeater, the Network Radius should be set to 2. If the Network
Radius is set to 2, a message from that node will only pass 2 hops before it is blocked.
The default setting is 1.
When base station is configured as a ‘Base-Repeater’ (used for remote peer to peer operation via the base
station), the use of Network Radius does not change and works the same as if it were a Base Station i.e. the
Network Radius is always the number of hops from the base station to the most distant remote in the
network.
All stations in the network should be set to the same value.
To Next Page
Loading...
