Ethernet > L2 Filtering
This page is only available if the Ethernet traffic option has been licensed (see ‘Maintenance > Licence’ on
page 270).
FILTER DETAILS
L2 Filtering provides the ability to filter (white list) radio link user traffic based on specified Layer 2 MAC
addresses.
User traffic originating from specified Source MAC Addresses destined for specified Destination MAC
Addresses that meets the protocol type criteria will be transmitted over the radio link.
User traffic that does not meet the filtering criteria will not be transmitted over the radio link.
Management traffic to the radio will never be blocked.
Source MAC Address
This parameter sets the filter to the Source MAC address of the packet in the format ‘hh:hh:hh:hh:hh:hh’.
If the Source MAC Address is set to ‘FF:FF:FF:FF:FF:FF’, traffic will be accepted from any source MAC
address.
Destination MAC Address
This parameter sets the filter to the Destination MAC address of the packet in the format
‘hh:hh:hh:hh:hh:hh’.
If the Destination MAC Address is set to ‘FF:FF:FF:FF:FF:FF’, traffic will be delivered to any destination MAC
address.
To Next Page
Loading...
