IP > IP Setup > Router Mode
This page provides the setup for the IP Settings for and Ethernet Operating Mode of ‘Router’.
PORT SETTINGS – port (n)
Note: This screen is dependent on the Data Port product option purchased (see ‘Data Interface Ports’ on
page 401). The Data Port product option shown is a 2E2S – two Ethernet ports and two Serial ports
IP Address
Set the static IP Address of the radio Ethernet port (n) assigned by your site network administrator using the
standard format xxx.xxx.xxx.xxx. This IP address is used for this Ethernet port Router mode.
Subnet Mask
Set the Subnet Mask of the radio Ethernet port (n) using the standard format xxx.xxx.xxx.xxx. The default
subnet mask is 255.255.0.0 (/16).
Gateway
Set the Gateway address of the radio Ethernet port (n), if required, using the standard format xxx.xxx.xxx.
A default gateway is the node on the network that traffic is directed to when an IP address does not match
any other routes in the routing table. It can be the IP address of the router or PC connected to the base
station. The default gateway commonly connects the internal radio network and the outside network. The
default Gateway is 0.0.0.0.
To Next Page
Loading...
