Protocol
This parameter sets the L4 TCP / IP or UDP / IP protocol used for terminal server operation. The default
setting is TCP.
Gateway IP Address
This Terminal Server parameter sets the Gateway IP address of a router in the network that serves as the
forwarding router to other networks when no other route specification matches the destination IP address
of a packet.
This is useful when default gateway IP address of the radio and the Terminal Server Gateway IP Address are
on different IP subnet networks.
When all radios are in router mode (GRM / RM) or advanced router mode (AGRM / ARM), the default gateway
IP address of the radio and Gateway IP Address of the Terminal Server are the same, leaving the Gateway
IP Address on the default value of 0.0.0.0 will serve the purpose. Only when the radio and Terminal Server
are with different IP subnets and are connected to different router gateway IP addresses, the default value
shall be set to the appropriate gateway IP address.
To Next Page
Loading...
