Aprisa SR+ User Manual 1.11.1
Parameter to show the number of broadcast packets received from the customer into the
Ethernet port. Broadcast packets are good packets received that were directed to the
broadcast address. Note that this does not include multicast packets.
Parameter to show the number of multicast packets received from the customer into the
Ethernet port. Multicast packets are packets that were directed to a multicast address.
Note that this number does not include packets directed to the broadcast address.
Parameter to show the number of VLAN tagged frames received from the customer into
the Ethernet port, including filtering, congestion but excludes VLAN dropped packets.
Parameter to show the number of VLAN tagged frames received from the customer into
the Ethernet port that were dropped due to filtered VLAN frames (filtering configuration
in VLAN configuration). L3 filtered packets, bad packets or congestion dropped packets
are not counted in this parameter.
Parameter to show the number of errored packets received from the customer into the
Ethernet port caused by CRC errors, FCS Errors, alignment errors, oversized packets,
undersized packets, fragmented packets and jabber packets.
Parameter to show the number of errored bytes received from the customer into the
Ethernet port.
Parameter to show the number of CRC / alignment errors received from the customer into
the Ethernet port. CRC / alignment errors are defined as frames that had a length
excluding framing bits, but including FCS octets of between 64 and 1518 octets, inclusive,
but had either a bad Frame Check Sequence (FCS) with an integral number of octets (FCS
Error) or a bad FCS with a non-integral number of octets.
Parameter to show the number of undersized packets received from the customer into the
Ethernet port. Undersized packets are less than 64 octets long excluding framing bits, but
including FCS octets.
Parameter to show the number of oversized packets received from the customer into the
Ethernet port. Oversized packets are longer than 1518 octets excluding framing bits, but
including FCS octets.
Parameter to show the number of fragmented packets received from the customer into
the Ethernet port. Fragmented packets have either a bad Frame Check Sequence (FCS)
with an integral number of octets (FCS Error) or a bad FCS.
Parameter to show the number of jabber packets received from the customer into the
Ethernet port.
Dropped Packets
(congestion)
Parameter to show the number of dropped packets received from the customer into the
Ethernet port due to congestion i.e., when the Ethernet port 125 packet buffers are full,
the next received packet on the ingress Ethernet port will be dropped.
Dropped Packets (filtering)
Parameter to show the number of dropped packets received from the customer into the
Ethernet port caused by packet L2 / L3 filtering.
Dropped Bytes (filtering)
Parameter to show the number of dropped bytes received from the customer into the
Ethernet port caused by packet L2 / L3 filtering.
To Next Page
Loading...
