Protection Switch MAC address
This parameter is only applicable when the radio is part of a Protected Station.
This Protection Switch MAC address is used to define the MAC address of the Protection Switch. This address
is entered in the factory. Both Protected Station radios read and use this MAC address.
This MAC address entry will only be used by the software if it detects that the factory MAC address set in
the internal EPROM of the protected switch is corrupted for some reason, otherwise the software will ignore
the MAC address entered by the user.
The Protection Switch MAC address is used for registration process only. For example, in a remote Protected
Station, both radios share the same RF MAC address and a single entry of the remote Protected Station will
be presented in network table (Network Status > Network Table).
The Protection Switch MAC address is shown on the Protection Switch label:
PRIMARY / SECONDARY CONFIGURATION
See ‘Maintenance > Advanced’ on page 276 for parameter details.
PRIMARY / SECONDARY MAINTENANCE FILES
See ‘Maintenance > Advanced’ on page 276 for parameter details.
To Next Page
Loading...
