IP address segregation of IP Terminal Server and radio management
The following figure describes the IP address segregation of IP Terminal Server and radio management where
the IP Terminal Server in Base station is configured with different IP address and subnet from the radio
management IP addresses and subnet.
IP address Configuration per Terminal Server in Router Mode
There are minor differences in configuring the IP address of a remote Terminal Server and/or IP Terminal
Server in Router mode / Gateway Router mode or Advanced mode of both options.
Router Mode / Advanced Router Mode:
• IP Terminal Server – the IP address must be the same as any Ethernet port IP address or PVIP of
protected station.
• Remote Terminal Server – the IP address must be the same as Ethernet port 1 (management) IP
address or PVIP of protected station.
Gateway Router Mode / Advanced Gateway Router Mode:
• Terminal Server – the IP address must be the same as the radio IP address or PVIP of protected
station.
To Next Page
Loading...
