Operation Manual / 4 Product description / A130-M.. - A145-M..
e work Page 57 /
© Copyright 2017 ABB. All rights reserved.
6.4.3 Compressor-end, non-rotating parts
Handling operating materials and supplies
Swallowing or inhaling vapours of operating materials and supplies or con-
tact with them may be harmful to health.
Do not breathe in these substances and avoid contact with the skin.
Ensure proper ventilation.
Observe the information in the material safety data sheet for the operating
materials and supplies.
Wear personal protective equipment (PPE) according to the material safe-
ty data sheet.
Comply with local legislation.
Wear safety goggles.
Wear safety gloves to protect against chemical hazards.
Wear a respiratory mask to protect against gases.
The following parts, which are relevant in terms of performance, can be cleaned in accordance
with the description below.
Figure 25: Compressor-end, non-rotating parts
72000 Compressor casing
77000 Wall insert
79000 Diffuser
Steam-clean the above-mentioned components or soak in diesel oil or water with house-
hold cleaning agents. After soaking, remove contamination with a brush.
Dry components completely.
Spray cleaned surfaces with penetrating oil. Do not spray exterior surfaces of the turbo-
charger.
Dispose of contaminated water and cleaning agents in accordance with the information in
the material safety data sheet.
To Next Page
Loading...
