ABB A135-M65 - 7 Eliminating Malfunctions; Malfunctions When Starting; Table 17 Malfunctions When Starting; Table 18 Malfunctions When Starting - Rubbing of Rotating Parts

Operation Manual / 4 Product description / A130-M.. - A145-M..
7
Eliminating malfunctions
Page 65 /
121
© Copyright 2017 ABB. All rights reserved.
HZTL4031_EN
Revision E
January 2017
7 Eliminating malfunctions
7.1 Malfunctions when starting
Delayed start-up
Possible causes
Remedy
Turbocharger Turbocharger contaminated Clean (see chapter Periodic maintenance
work [➙ 45])
Bearing damaged Contact ABB Turbocharging Service
Station
Rotor rubbing
Foreign object in the turbocharger
Table 16: Malfunctions when starting – Delayed start-up
Vibrations
Possible causes
Remedy
Engine Vibrations from engine Contact enginebuilder
Turbocharger Rotor unbalance Contact ABB Turbocharging Service
Station
Turbine or compressor damaged
Bearing damaged
Table 17: Malfunctions when starting – Vibrations
Rubbing of rotating parts
Normal behaviour, not a malfunction
Turbocharger A minimal and uniform wear at the circumference of the rotor components caused by
slight local rubbing against adjacent components is permitted. This causes the com-
pressor or turbine blades to be somewhat shortened. To prevent significant loss of effi-
ciency, specific tolerances must be fulfilled.
 If there is any doubt about the extent of the rubbing, contact an ABB Turbocharging
Service Station.
 Have a dimension check carried out by an ABB Turbocharging Service Station.
Table 18: Malfunctions when starting – Rubbing of rotating parts