ABB ACQ80-04 - Page 45

Parameters List 45
EN
TR
ZH
58.04 Baud rate 0…7 - 19.2 kbps[3]
58.05 Parity 0…3 - 8 EVEN 1[2]
58.06 Communication control Enabled[0], Refresh
settings[1], Silent mode[2]
- Enabled[0]
58.07 Communication diagnostics 0000h…FFFFh - 0b0000
58.08 Received packets 0…4294967295 - 0
58.09 Transmitted packets 0…4294967295 - 0
58.10 All packets 0…4294967295 - 0
58.11 UART errors 0…4294967295 - 0
58.12 CRC errors 0…4294967295 - 0
58.14 Communication loss action Not applicable.
58.15 Communication loss mode Any message[1], Cw / Ref1 /
Ref2[2]
-
Any
message[1]
58.16 Communication loss time 0.0…6000.0 s 60.0
58.17 Transmit delay 0…65535 ms 0
58.18 EFB control word 0000h…FFFFh - 0.0.0.0
58.19 EFB status word 0000h…FFFFh - 0.0.0.0
58.25 Control profile ABB Drives[0], DCU Profile[5] - ABB Drives[0]
58.26 EFB ref1 type
0...5 -
Speed or
Frequency[0]
58.27 EFB ref2 type Not applicable.
58.28 EFB act1 type
See parameter 58.26 -
Speed or
frequency[0]
58.29 EFB act2 type Not applicable
58.31 EFB act1 transparent source
Not selected [0], Other -
Not selected
[0]
Note: Applicable only when 79.40 MPPT reference is disabled. If parameter MPPT reference is
enabled, then the parameter should be set to it’s default value.
58.32 EFB act2 transparent source Not applicable
58.33 Addressing mode Mode 0[0], Mode 1[1], Mode
2[2]
- Mode 0[0]
58.34 Word order HI-LO[0], LO-HI[1] - LO-HI[1]
Index Name Range/List Unit Default
Autodetect[0] 9.6 kbps[2] 38.4 kbps[4] 38.4 kbps[4]
4.8 kbps[1] 19.2 kbps[3] 57.6 kbps[5] 57.6 kbps[5]
8 NONE 1[0] 8 NONE 2[1] 8 EVEN 1[2] 8 ODD 1[3]
Bit Name Bit Name Bit Name Bit Name
0 Init failed 4 Wiring error 8 No packets 13 Protocol 1
1 Addr config err 5 Parity error 9 Noise or addressing error 14 Protocol 2
2 Silent mode 6 Baud rate error 11 CW/Ref loss 15 Internal error
3 Autobauding 7 No bus activity 12 Not active
Speed or frequency[0] Transparent[1] General[2] Speed[4] Frequency[5]
Note: Applicable only when 79.40 MPPT reference is disabled. If parameter MPPT reference is
enabled, then the parameter should be set to it’s default value.
ACQ80R0-R8 QIG.book Page 45 Friday, February 1, 2019 1:18 PM