ABB COMMANDER 351 - Page 33

31
8
Heat/Cool Output 1 Start
This parameter defines the PID output value above which
Output 1 (heat) becomes active.
[0.0 to 100.0%]
Heat/Cool Output 2 Start
This parameter defines the PID output value below which Output
2 (cool) becomes active.
[0.0 to ≤ Y1st %] – see Heat/Cool Output 1
Return to top of page
3 SET UP MODE…
2.22...2.23…3.2 Level 2 – Tune
•1 Displayed only if a Heat/Cool output type is selected – see Section 4.2, Basic Configuration/ Output
Type.
50.0
Y2.St
2...23
50.0
Y1.St
2...22
LEV2
tUNE
•1
•1
Output 2
PID Output
0%
100%
100%
0%
Y2.St Y1.St
Output 1
Output 2
PID Output
0%
100%
100%
0%
Y2.St Y1.St
Output 1
Reverse-direct
or direct-reverse
Reverse-reverse
or direct-direct