ControlMaster CM30, CM50 and CMF310
Universal process controllers,
1
/4,
1
/2 DIN and fieldmount 7 Advanced Level
38 IM/CM/ED–EN Rev. X
…Display
Operator Functions
Autoscroll When enabled (On), Operator pages (see page 23) are scrolled continuously
at intervals of 10 seconds per page.
Soft Key Function Assigns a dedicated function to the Navigation key (right) – see page 6.
Configuration
Displays the Access Level enabling selection of configuration levels – see page 24.
Auto/Manual
Toggles between Auto and Manual control modes.
Local / Remote
Toggles between Local and Remote setpoint modes.
Scroll View
Scrolls through each available Operator view.
Alarm Ack
Acknowledges all active unacknowledged alarms.
Toggle Signal
Provides a source that toggles between 2 states – can be assigned to outputs
or used to select sources.
Edge Signal
Provides an edge-triggered source that is active on key press.
Can be assigned to outputs or used to select sources
Auto Manual Enable Turns on / off the ability for Auto / Manual control mode to be changed in
Operator Level.
Local Remote Enable Turns on / off the ability for local / remote setpoint mode to be changed in
Operator Level.
Alarm Ack. Enable Turns on / off the ability to acknowledge alarms from the front panel.
Totalizer Stop/Go Turns on / off the ability to start / stop the totalizer.
Totalizer Reset Turns on / off the ability to reset the totalizer.
SP Adjust Enable Turns on / off setpoint adjustment in the Operator Level.
Profiler
Select Program
Enables the program to be selected in the Operator Level.
Program Control
Enables the program control functions to be available in the Operator menus
(Run, Stop, Hold, Reset).
Segment Control
Enables the segment control functions to be available in the Operator menus
(Skip Segment, Repeat Segment).
To Next Page
Loading...
