ControlMaster CM30, CM50 and CMF310
Universal process controllers,
1
/4,
1
/2 DIN and fieldmount 7 Advanced Level
34 IM/CM/ED–EN Rev. X
7 Advanced Level
7.1 Device Setup
Provides access to standard setup parameters to determine the type of
control / indication required. Also provides the ability to create non-standard
configurations for special application requirements.
Initial Setup
App Template Application templates enable standard configurations for particular applications to be
created as simply as possible. When a template is selected, the controller assumes the
preset form for that template. The inputs and function blocks are
soft-wired automatically to perform the selected function.
See Section 8, page 88 for templates available to Extended and Dual functionality
controllers.
Loop 1 (2) Output Type The appropriate output function block, relay, digital and analog outputs are configured
and soft-wired.
Loop 2 Output Type is available only if a Dual Loop application template is selected –
see Section 8, page 88 for template details.
See Appendix D, page 109 for output assignments.
Loop 1 (2) Split O/P Loop 1 Split O/P is available only if the Loop 1 Output Type is Split Output.
Loop 2 Split O/P is available only if a Dual Loop or Cascade application template is
selected and the Loop 2 Output Type is Split Output.
These types of outputs split the Control (PID) output signal (see page 30) into 2 signals.
The linear relationship between the PID O/P and the 2 outputs can be configured in the
Control configuration – see page 46.
See Appendix D, page 109 for output assignments.
Instrument Tag A 16-character alphanumeric tag, displayed in the title bar on Operator pages – see
page 23.
Loop 1 (2) Tag Available only if a Cascade or Dual Loop application template is selected – see Section
8, page 88 for template details.
The tag is displayed in Operator pages – see page 23.
Mains Freq Used to set the internal filters to reduce mains power frequency interference.
Menu
Device Setup
Exit
Select
To Next Page
Loading...
