ControlMaster CM30, CM50 and CMF310
Universal process controllers,
1
/4,
1
/2 DIN and fieldmount 7 Advanced Level
IM/CM/ED–EN Rev. X 35
…Device Setup / …Initial Setup
Config Action The Config Action parameter is used to determine how the controller and controller
outputs behave when the Advanced level is entered – see page 34.
Continue
The controller continues to operate as in the operator level. Outputs continue
to operate as normal.
Hold
Puts the controller into Manual control mode.
When the Advanced level is exited, the controller returns to the pre-configuration
mode of operation.
Digital, relay and analog outputs are held at their value / state when configuration
mode is entered.
Inactive
Puts the controller into Manual control mode.
When the Advanced level is exited, the controller returns to the pre-configuration
mode of operation.
Digital and relay outputs are turned off.
Analog outputs are set to 0 mA.
Custom Template If this parameter is enabled, it enables the internal function blocks to be re-linked
to create custom configurations for special application requirements.
These sources are configured in Device Setup / Custom Config – see below.
Analog 1 Eng. Units
Analog 2 Eng. Units
Configurable units that can be assigned to any analog signal
(Analog I/P or Math Block).
Tot . 1 E n g . U n it s
Tot . 2 E n g . U n it s
Configurable units that can be assigned to any totalizer.
Reset to Defaults Resets all configuration parameters to their default values.
Security Setup 3 Security access levels are provided, each protected by a password of up to
6 alphanumeric characters.
Note. Passwords Basic and Advanced level are not set at the factory and must
be entered by the end user(s).
Basic Password Basic level provides access to the Basic level parameters – see Section 6, page 28.
Advanced Password Provides access to all configuration parameters – see Section 7, page 34.
Reset Passwords Resets all passwords to factory values.
To Next Page
Loading...
