ControlMaster CM30, CM50 and CMF310
Universal process controllers,
1
/4,
1
/2 DIN and fieldmount 7 Advanced Level
36 IM/CM/ED–EN Rev. X
…Device Setup
Custom Config
Loop 1 (2) PV
Sets the source for the process variable.
Loop 1 (2) Split O/P
Sets the source for output to the split output function block.
Loop 1 (2) Valve Mode
Sets the valve operation mode, Feedback or Boundless – see page 31.
Loop 1 (2) Valve O/P
Sets the control input to the valve function block.
Loop 1 (2) Valve FB
Sets the source for position feedback input.
Loop 1 (2) TP OP1
Sets the source for control input to the time proportioning block for Output 1 –
see page 34.
Loop 1 (2) TP OP2
Sets the source for control input to the time proportioning block for Output 2 –
see page 34.
Loop 1 (2) RSP
Sets the source for the remote (external) setpoint.
IrDA Configuration Allows the device configuration to be backed-up (read) from the device,
or written to the device over the IrDA interface to a PC –
see Section 9, page 97 – PC Configuration.
Setup
Select Mode Select the IrDA Configuration operating mode.
Off
IrDA Configuration mode is turned off.
Read-Only
Enable reading of the device configuration.
Read/Write
Enable reading and writing of the device configuration.
Config. Description A 24-character alphanumeric descriptor used to assist in identifying the
configuration that is read from or written to the device.
To Next Page
Loading...
